BatsSoft.nl/computer

Deze pagina is alleen-lezen. Je kan de broncode bekijken maar niet veranderen. Neem contact op met de beheerder als je denkt dat dit niet klopt.
====== sp0038 ======

---- dataentry compaq_softpaq ----
Extensie  : zip
Grootte   : 12 kB
Titel     : LTPENDRV.SYS is a driver to be used with CBTP.COM or PCMIS.COM files on most COMPAQ computers with VGA using TDS light pen software.
Versie    : 
Taal      : 
Producten : 
OS        : 
Vervangt  : 
----

===== Uitgepakte bestanden =====

^ Bestand      ^
| CBTP.COM     |
| LTPENDRV.SYS |
| PCMIS.COM    |
| TDSPEN.DOC |

===== Tekst-bestanden =====

<file txt TDSPEN.DOC>

                     INSTALLATION INSTRUCTIONS

 INTRODUCTION:

     LTPENDRV.SYS is a driver to be used with CBTP.COM or PCMIS.COM 
     files on most COMPAQ computers with VGA that has problem using 
     TDS light pen software from TDS Healthcare Systems Corporation. 

 SYSTEM REQUIREMENTS:

     Deskpro 286e
     Deskpro 286N
     Deskpro 386/20
     Deskpro 386N
     Deskpro 386s
     Deskpro 386s/20
     Deskpro 386/25
     Deskpro 386/20e
     Deskpro 386/25e
     Deskpro 386/33
     Deskpro 386/33L
     Deskpro 486/25
     Deskpro 486/33L
     Systempro 386
     Systempro 486

     COMPAQ MS-DOS Version 2 or greater.

 WHO SHOULD USE:

     Use this program if you are having problems using TDS light pen 
     software on the above COMPAQ computers.

 HOW TO USE:

     1.  Copy the program LTPENDRV.SYS from the distribution
         diskette to your system diskette or fixed disk.

     2.  Using an editor, add a line to your CONFIG.SYS file to
         execute the command at system boot.

     3.  The syntax of the program is:
               DEVICE=[d:][path]LTPENDRV.SYS
         
         Comments:  There are no command line parameters.

     4.  When the package is successfully installed, you will get
         the following message:

               LTPENDRV.SYS is Installed.
               (C) Copyright COMPAQ Computer Corp.  1991

         If the package is not successfully installed, an error
         message will be generated.

     5.  Copy the program CBTP.COM to the subdirectory where the 
	 program CBTP.EXE will be run from.

     6.  Copy the program PCMIS.COM to the subdirectory where the
	 program PCMIS.EXE will be run from.


 EFFECTS ON YOUR SYSTEM: 

     1.  Since the file LTPENDRV.SYS is a device driver it will use 
         approximately 1000 bytes of system memory.

     2.  Once installed, the program cannot be unistalled until the
         system is rebooted.




</file>