overig:compaq:softpaq:sp0030
Verschillen
Dit geeft de verschillen weer tussen de geselecteerde revisie en de huidige revisie van de pagina.
Beide kanten vorige revisieVorige revisieVolgende revisie | Vorige revisie | ||
overig:compaq:softpaq:sp0030 [08-01-2022] – aangemaakt michel | overig:compaq:softpaq:sp0030 [08-01-2022] (huidige) – aangemaakt michel | ||
---|---|---|---|
Regel 4: | Regel 4: | ||
Extensie | Extensie | ||
Grootte | Grootte | ||
- | Titel : This program will prevent system lockup and screen display problems seen with COMPAQ | + | Titel : This device driver enables an IBM Enhanced Graphics Adaptor (EGA) to be run in any COMPAQ |
Versie | Versie | ||
Taal : | Taal : | ||
Regel 15: | Regel 15: | ||
^ Bestand | ^ Bestand | ||
- | | NEWMENU.COM | + | | MNMIHEEM.DOC | |
- | | NEWMENU.DOC | + | | MNMIHEEM.SYS | |
===== Tekst-bestanden ===== | ===== Tekst-bestanden ===== | ||
- | <file txt NEWMENU.DOC> | + | <file txt MNMIHEEM.DOC> |
- | + | | |
- | + | ||
- | | + | |
| | ||
Regel 29: | Regel 27: | ||
INTRODUCTION: | INTRODUCTION: | ||
- | This program will allow a COMPAQ 386 system to run the NURSING STAFFING | + | MNMIHEEM.SYS is a program executed from CONFIG.SYS that allows an IBM |
- | | + | EGA adapter to function properly in any Compaq 486-based system. |
- | by WAUSAU Hospital.) | + | |
SYSTEM REQUIREMENTS: | SYSTEM REQUIREMENTS: | ||
- | Any COMPAQ 386 system. | + | |
- | COMPAQ | + | |
+ | 2. Has an IBM EGA adapter installed. | ||
+ | | ||
WHO SHOULD USE: | WHO SHOULD USE: | ||
- | Use this program if you cannot display | + | When an IBM EGA adapter is placed in a Compaq 486-based system, three |
- | STAFFING PROGRAM and the system hangs. | + | beeps (one very long, two long) occur during initialization. |
+ | machine then boots in 40-column mode. In an MS-DOS environment, | ||
+ | adapter can be returned to 80-column mode by typing MODE CO80 from a | ||
+ | DOS prompt, however, all EGA functionality is NOT regained. | ||
HOW TO USE: | HOW TO USE: | ||
- | | + | |
- | that contains | + | from, using the DOS copy command: |
- | 2. To run MENU.EXE, make the current directory the one which contain | + | copy a:\mnmiheem.sys d: |
- | MENU.EXE and the patch file. Type MENU.EXE and press < | + | |
- | Any command line parameters that were used with MENU.EXE can be | + | |
- | added before pressing < | + | |
- | 3. You will see the following message when the program is run: | + | where d: |
+ | | ||
- | | + | Using the file editor of your choice, place the following line as the |
- | (C) Copyright COMPAQ Computer Corp. 1990 | + | first line in the CONFIG.SYS file: |
- | 4. If you usually start MENU.EXE in your AUTOEXEC.BAT, edit your | + | |
- | | + | |
+ | When the system boots, the beeps described above still occur, but | ||
+ | | ||
+ | displays in 80-column mode. No installation messages are given. | ||
EFFECTS ON YOUR SYSTEM: | EFFECTS ON YOUR SYSTEM: | ||
- | 1. NEWMENU.COM version 1.00 will require around 900 bytes of memory. | + | After re-initializing the EGA adapter, this program leaves no residue |
- | + | in your system. | |
- | + | ||
</ | </ |
overig/compaq/softpaq/sp0030.1641602695.txt.gz · Laatst gewijzigd: 08-01-2022 door michel