DATAP.COM
INSTALLATION INSTRUCTIONS
INTRODUCTION:
DATAP.COM is a TSR program for use with a COMPAQ computer that
is experiencing timeout errors with the "DATA PHYSICS CORPORATION"
solution in signal processing software with a DP420 board.
SYSTEM REQUIREMENTS:
COMPAQ SLT/286 or SLT 386s/20 or LTE 386s/20.
DATA PHYSICS CORPORATION FFT analyzer software
DP420 board
WHO SHOULD USE:
Use this program if you are getting TIMEOUT errors when running
SIGNAL.EXE
HOW TO USE:
1. Copy the program DATAP.COM from the distribution
diskette to the fixed disk subdirectory containing the
FFT analyzer software. (i.e. \FFTA)
2. If you use the program RUNFFTA.BAT to start your analyzer
software, then you may just copy the new program RUNFFTA.BAT
from the distribution diskette to the fixed disk subdirectory
containing the FFT analyzer software. (i.e. \FFTA)
3. If you do not start your analyzer software with RUNFFTA.BAT,
then you should enter the following before executing SIGNAL.EXE.
DATAP (Enter)
Then when you exit your analyzer software, after executing
SIGNALDE.EXE, You should enter the following:
DATAP U (Enter)
EFFECTS ON YOUR SYSTEM:
1. Since this is a TSR (Terminate & Stay Resident) program,
it will use approximately 480 bytes of system memory.
2. Once installed, the patch can be uninstalled by executing
it again with a "u" on the command line, thereby freeing
the 480 bytes of system memory.